![]() Install the ASCOM platforma and Celestron Driver with Starry Night Pro not running. Clicked the CONNECT button which is next to the configure button you clicked above in the setup section of the Starry Night Pro Telescope tab. Hit OK button on ASCOM Telescope Chooser window.Ĥ. Expand this item by clicking on the + button next to it. Look over the list until you find one labeled PORTS (COM & LPT). This will open up a list of branching information. Then when the new window opens select DEVICE MANAGER from the left side of the window. ![]() ****To figure out what serial port your computer is using for your scope, you need to right click on MY COMPUTER in the start menu and select PROPERTIES. Clicked properties next to the above drop down list and selected your scope from the SCOPE TYPE list AND selected the correct serial port right under the SCOPE TYPE list depending on what your computer says the COM port is that you are using for connecting to your scope. Selected Celestron Scope Driver from the ASCOM Telescope Chooser drop down list.ī. Gone under Telescope Tab in Starry Night Pro and clicked CONFIGURE button under the set up section and then did the following:Ī. Have Celestron Scope Drivers for ASCOM installed? ( Celestron Unified (5.0.23))ģ. Have ASCOM platform installed? ( ASCOM Platform 6)Ģ. Getting "Failed to create or open the plug-ins registry area". If not let me know and I will open up my software and try to type out precise instructions rather than all of this by memory after doing it once. The NUDGE feature in the starry night software works a little differently. This is useful to make skews just like using the hand control on the telescope. Click it.Īt some point in the set up you can choose to have a hand control window open up. After the is done you will have closed out of the scope setup window and then under the telescope tab next to the configure button is a connect button. If you are attaching using a USB to serial adapter, you should be able to go to DEVICE MANAGER in windows and down to the ports section to see what COM port has been assigned to the USB to serial adapter which will be how the software will find your scope if that's how you have plugged your scope into your computer.īack to starry night, after you selected the right scope ascot driver and COM port, you will then choose the right celestron scope from a list. This has to be the right one for the software to find your attached scope. Either here or in the next window you select the COM port. It should now give you a drop down box to select the type of scope driver. ![]() Then find the all in one celestron scopes driver. On the left of the downloads page, select telescopes. The go back to the ascom site and go to downloads page. On the homepage they have a link to download the latest and greatest platform version. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |